May 21st 2021

Precision Bore Guide Instructions

  1. Remove bolt from rifle
  2. Thread brass onto end A of Precision Bore Guide.
  3. Slide Precision Bore Guide into action.
  4. Rotate collar B until the set screw is facing out of the action.
  5. Center collar B in action and tighten the set screw.
  6. Push Precision Bore Guide securely into chamber using knob C and rotate into the same position bolt would normally close.
  7. Spray desired solvent directly into the back of the Precision Bore Guide and follow manufacturers instructions on wait time.
  8. Insert cleaning rod through the back of the Precision Bore Guide to clean the bore.
  9. Once the bore is cleaned to satisfaction, remove the Precision Bore Guide from the action.
  10. Spray the inside of the Precision Bore Guide as well as brass with WD-40 or similar cleaner before storing.